This object is considered as «large» for trajectory purposes. Although we used only a «simple» type of trajectory, with fewer frames, all of the intricate curvatures were successfully captured.
Product part made of plastic. Scanning time was around 5 minutes, and post-processing took about 20 minutes. This is a good example of fast reverse engineering.
The cap was made of semi-transparent plastic and required a bit of dusting with an airbrush. Then it was mounted on the scanner’s rotating platform with a clamp. A couple of mouse clicks — and scanning commenced.
The complete model of this Smart car was created from approximately 10-13 scans taken from various positions around all sides of the vehicle. We also took two scans from below, with the car raised on a car lifter.
Leather surfaces often reflect the white glare from a scanner's flash. In order to prevent that we slightly tilted the scanner to avoid scanning at a 90° angle.
This ordinary office Troll was scanned with an Artec Leo 3D scanner. In exchange for the promise of some meaty morsels, the troll agreed to pose for the scanning by leaning on a chair that was later removed during post-processing in Artec Studio.
This small turbine was scanned in three passes using a rotating table — this enabled the operator to easily capture all the curves from different angles with less hand motion.
